Additional Notes for 2007-2008 Hammer Low Beam


In addition to the installation notes provided here, the following modifications are required for the LOW BEAM ONLY, for the following model years: 2007 & 2008 Hammer. THESE INSTRUCTIONS DO NOT APPLY TO ANY OTHER MODELS.

1.) Remove OEM low beam
bulb from headlight.
2.) Unplug bulb from plastic housing. 3.) Drill or cut a hole from bottom of the bulb. 4.) Use care not to destroy the plastic housing. 5.) Run HID bulb wires through the hole.


Your IP Address is:
Copyright © 2019 VictoryHID. Powered by Zen Cart